"A Complete Guide to all Things Manufactured"
|
77
78
Support the bracket (A-5) and insert front brace into slot 9 and 7. Fold in cardboard
applicator and twist counterclockwise until it "click". Take front board (G-1) and both
support rods (K-1), (K-2) and lay on flat, hard surface. (NOTE: DO NOT ATTEMPT TO LAY
BOARDS ON RUG OR CARPET. MAKE SURE SURFACE IS HARD AND FLAT.) Insert
support rods into corresponding holes (HOLE 6 & 7).
7. Remove pegs from back beam (W-1) by placing using a screwdriver and hammer to
"punch" out the holes. Place screwdriver on edge, and lightly tap screwdriver with hammer.
8. Gently insert bottom rod (X-3) through holes in back beam. Insert buckle clip through
back beam (W-1) and tighten both screws on opposite edge. Use thumb to support
second string on fourth jumper. Use "Uncle Berry's Rock Hard Glue" (Included in kit) to
form a straight line across beveled edge. (NOTE: DO NOT USE TOO MUCH GLUE.)
9. Attach fastening sheet to second hole and push inward, then twist. Allow six hours to
dry before using.
MAINTENANCE:
For best results, always use Three Chord Mafia brand cleaner. Wax in a side motion, and
wipe excess cleaner from motor. Refer to diagram and instruction below.
DISCOGRAPHY:
Three Chord Mafia has no releases yet. Sorry :(